When I went to see this bed, a few months ago, it was quite a lovely sight to see. The timber is Olive wood and has a beautiful patina, with lots of knots dug out and replaced with small pieces of Olive, in the most simple of ways, that just looked great..and it's heavy..much heavier than you think as you go to pick it up.
The bed has been in the same family for three generations, and there was no way that it was going to be ruined in any way..
The family came to my workshop to see what I do, and what I could do for them. I must admit, at first I got the wrong end of the stick, I was being asked if I could just extend it by 300 or so millimeters.. You just can't add 300 mm to the length of a bed, especially if a teenage boy is the user.. unless I added some more structural timber inside.. So I mentioned cutting the sides down to use as fascia covers over new longer structural rails..this didn't go well either..
A little while later they got back in touch with me to make two new side rails for the bed..in hardwood..So I then suggested that the original rails could be just hung beneath the bed, hanging from the slats..That way the bed could easily be put back to how it was..
So I'm just adding to the history of this piece..it could always go back to how it was...Brilliant.
I didn't take any before pics..
The insides were painted, side rails showing Tenons and hand made bolts..
Just look where the nuts are hidden inside, just behind those infill blocks..cool
This is where new meets old..notice the two notches..
The dowel is to stop the slats from moving around, and it fits the edge of the first slat..
The new rails are in a single piece of Sapele, cut from a 6m length, with some figuring and mottling and it's strong. Not a bad colour match too. All of the tenons were cut buy hand, they had to be, because all of the mortices were different..good fun fitting each one..They weren't straight, or equal, or square.. and they will not be interchangeable. and I never took any timber out of the mortice.
Here are the ends of the new rails. I had to fit the bolts to the centres on the end frames..
so the bolt hole weren't in the middle of the tenons..
Notice the nut holes are behind some end grain pegs or stoppers..just proud..
You can see the difference in lengths,
but also just how much bow is in the original Olivewood rails
The colours look better in this pic
This is the head end..just 1/4" higher, but with a round on top
I delivered the bed this week, I went into their beautiful house and assembled it.. With a new longer mattress now, and safe in the knowledge that it will last for a few more decades.
All the best
Jamie
